I thought I would test this skimmer, play with all the water levels and get a feel for it before I put it in my DT. I would really of liked a shoot out with differant skimmers, drip skimmate and see which sucks the most;)
Herewith pix and tests so far
out the box
hows this for a pump
I put about 70l in a 3 foot tank, check the water level. On this water level, I did let it run, then would switch of the pump, did this a few times and there was no draw back from the out flow being between 20-50mm under. I did evn have the water level right up to half way up the neck, and still no flooding back when it restarts.
check the bubble formation in the cone, they so small you can't see them.
This is still NSW, check the gunk on top already
Now the fun starts, I went to the skimmer I got in the DT, I have been skimming wet and had about 1.5l's skimate, I thought I would pour it in a imagine in an hour it would skim it out.........well.....in seconds it just went mental, the top of the bubble column was just above the cone into the chamber............as I poured in the skimate in the BB just went mental.....obviously this is in more confined circumstances, but I at least thought it would take 15-30 mins let alone an hour
so now I collected the skim mate when it calmed down and had settled a bit, poured the skimate into a 2L to measure it.
While I was pouring the skim mate in, the skimmer just went mental.......absolute baboon, before I had finished pouring the 2L in, it was already gushing out the over flow hole (and this is after when the skimmer had settled again)